First Using Guide; Cable Map Testing - Pro'sKit MT-7071 User Manual

OPERATION
FIRST USE GUIDE
If this is you first operation, please follow the instructions carefully as below
before testing.
1. Please read user manual carefully and refer to page30:「Operating
process chart」 for learning operation instruction.
2. Please refer to page30: 「Operating process chart A. (Lang：)」 and
follow the procedures to select language: (Chinese/English).
3. Please refer to page30:「Operating process chart I.(Auto off time)」 ，
follow the procedures to select 15/30/60/120 min for auto power off time
setting.
4. Please refer to page30:「Operating process chart F.(Unit：)」 ，follow the
procedures to select unit：Meter / Feet /Yard.
5. If would like to change the setting, please follow the above instruction to
reset.
CABLE MAPPING
Caution!
•
When performing cable mapping, select standard 1 to 1 or optional 1 to
8 remotes; both of receiver and remote unit cannot be used at the same
time, otherwise, the LCD will show incorrect test result. Single conductor
cable cannot be used for cable mapping.
•
When performing cable mapping, do not connect the tested cable to any
electric circuit、equipment or adapter, it will affect the test result.
•
Measuring cable length: the length of Lan cable must be longer than 1m
(3 Ft / 1 Yard), and the others must be longer than 1.25m (4 Ft / 1.35
Yard)。Maximum measuring distance is 610m (2,000Ft / 666 Yards).
•
If short, open and crossover status occur at same time, "short" will show
up in first priority, please make the wire troubleshooting step by step.
11