Konica Minolta AccurioPress C2070 Troubleshooting Manual page 147

Actuator lifts up the edge of the not
Downstream
stiff and narrow width paper.
Paper entrance angle to the fusing
exit roller varies depending on the
paper
Fusing unit_Cross Section (Front view)
Conditions which symptom tends to occur more often
• Paper width: Approx. 100 to 110mm (Trailing edge corner of the paper interfere
with the actuator)
• Paperweight: 100gsm or less (Stiffness is very low and paper path is regulated by the
actuator before entering to the nipping part of the fusing exit roller)
(3) Solution
To change the paper entering angle to the fusing exit upper roller, adjust the temperature of the
fusing roller upper to + (plus) direction or fusing roller lower to the - (minus) direction and let the
paper move along the upper guide.
Note
When increasing the fusing upper roller, be careful not to cause the wrapping of the fusing upper
belt.
Table of contents
KONICA MINOLTA Confidential
Upstream
- 146 -