Konica Minolta AccurioPress C2070 Troubleshooting Manual page 102

When the conduction is not seen,
• Clean the following part with the drum cleaner. Red circled part
• Check the contact status of the spring material. If it is not enough, increase the
pressure. Blue circled part
Caution
If there is a gap between the joint of neutralization ring and fusing roller as NG picture, edge of
neutralization ring shave the spring, and claw of the spring breaks. In the case of non-electricity
conduction, check the below procedure.
In addition, when replacing fusing belt, note in below assembly.
KONICA MINOLTA Confidential
When the plate spring
gets deformed,
correct it..
- 101 -
Clean with the drum
cleaner.
Clean with the drum
cleaner.