Konica Minolta AccurioPress C2070 Troubleshooting Manual page 124

(c) Roller
Clean the roller to remove paper dust and any soilage or replace it.
(d) Add P1 load
When the paper stops at paper pick up roller or paper does not reach to the feed roller,
increase the weight on the pick-up roller (
photo below to increase the load.
Note
The screw may get loosened or steel plate position may move. So, carefully apply the
solution.
Do not attach the weight to C8000/7000/6000/6501/5501, as paper feed solenoid does not
move by the weight.
(e) Add P2 load
When the paper stops on the feed roller or paper leading edge stops at the downstream of
paper feed roller, change the P2 load to "Strong".
(Refer to the Service manual "Mechanical Adjustment→Separation pressure adjustment of
KONICA MINOLTA Confidential
65AA4008 Paper feed Auxiliary Plate)
Add one piece of
65AA4008
When the weight is added, the gap is created.
This may cause the loosened screw or shift of
the weight
- 123 -
Loosen the knob of the screw, move
the side plates then tighten again.
as shown in the