Martin Magnum 2500Hz User Manual page 5


Do not spill fluid over or inside the machine. If fluid is spilled, disconnect
AC power and clean with a damp cloth. If fluid is spilled onto electronic
parts, take the machine out of service and contact Martin Service and
Support for advice.

Do not remove the covers or attempt to repair a faulty machine. Refer
any service not described in this manual to Martin Service and Support.

Do not operate the machine if any parts are damaged, defective or
missing.

Moisture and electricity do not mix. Do not aim haze output at electrical
connections or devices.
P r e v e n t i n g b u r n s a n d f i r e

The haze produced by the machine is hot enough to cause burns when it
leaves the nozzle, and very hot droplets of fluid escape occasionally.
Keep people and objects at least 600 mm (24 in.) away from the haze
output nozzle.

Do not touch the haze output nozzle during or after use – it becomes
extremely hot and remains hot for several hours after the machine has
been shut down.

Haze output contains glycol, a flammable alcohol that burns with an
almost invisible blue flame. Do not point haze output at sources of
ignition such as open flames or pyrotechnic effects.

Do not attempt to bypass thermostatic switches, fluid sensors or fuses.

Replace fuses only with ones of the type and rating specified in this
manual for the machine.

Provide a minimum free space of 100 mm (4 in.) around the machine.

Provide a minimum free space of 500 mm (20 in.) around fans and air
vents and ensure free and unobstructed airflow to and around the
machine.

Keep the machine at least 600 mm (24 in.) away from combustible and
heat-sensitive materials.

Do not operate the machine if the ambient temperature (Ta) is below 5°
C (41° F) or above 40° C (104° F).

Do not operate the machine if the relative air humidity exceeds 80%.
P r e v e n t i n g i n j u r i e s

Ensure that the surface on which the machine is located or installed can
safely hold the weight of the machine.

Do not install the machine over areas where people are present.

Do not operate the machine with missing or damaged covers or shields.

In the event of an operating problem, stop using the machine
immediately and disconnect it from power. Do not attempt to use a
machine that is obviously damaged.

Do not modify the machine in any way not described in this manual or
install other than genuine Martin parts.

Refer any service operation not described in this manual to a qualified
technician.

Haze output can cause condensation. Do not point the output at smooth
floors. Floors and surfaces may become slippery. Check these frequently
and wipe dry as necessary to avoid any danger of slipping.

Ensure at least 2 m (6.6 ft.) visibility in areas where haze is being
produced.
Safety information
5