Sony LMD-X310MT Instructions For Use Manual page 19

For the HD/SD quad view setting, each connector is
compatible with the four division-images shown below.
 3G/HD/SD-SDI input/output connector (BNC
type)
SDI 2 (HD)
connector (input)
Input connector for serial digital component signals
2)
.
connector (output)
Signals input to the input connector are output to the
output connector.
1) Serial digital component signals are SMPTE ST 259
compliant (SD)/SMPTE ST 292-1 compliant (HD)/
SMPTE ST 424 compliant (3G).
2) Transmission distance
3G-SDI: 70 m (approx. 230 ft) max. (When using 5C-FB
coaxial cables (Fujikura. Inc.) or equivalent.)
HD-SDI: 100 m (approx. 328 ft) max. (When using 5C-FB
coaxial cables (Fujikura. Inc.) or equivalent.)
SD-SDI: 200 m (approx. 656 ft) max. (When using 5C-2V
coaxial cables (Fujikura. Inc.) or equivalent.)

SERIAL REMOTE connector (RJ-45)
Connect to the network by using a 10BASE-T/100BASE-
TX LAN cable (non-shielded type of 5 or more category,
optional).
The monitor can be operated according to control
commands sent from connected external equipment.
Consult your dealer in order to utilize the function.
Caution
For safety, do not connect the connector to peripheral

device wiring that might have excessive voltage.
Follow the instructions for use for this port.
 The connection speed may be affected by the network
system. This unit does not guarantee the
communication speed or quality of 10BASE-T/
100BASE-TX.

12V 1.7A output connector
Outputs 12 volts. (A connector for an option for future
use)

5V 1.6A output connector
Outputs 5 volts. (A connector for an option for future
use)
 DVI-D input/output connector
connector (input)
Input DVI Rev.1.0 applicable digital signal.
connector (output)
Active through output connector of the DVI digital
signal.
Note
Signals are output when the power is on. No signal is
output when the power is off. Signals protected with
1)
HDCP cannot be output.
1) HDCP (High-bandwidth Digital Content Protection) is a
copyright protection technology using encryption
technology of digital video signals.

SERIAL REMOTE RS-232C connector (D-sub
1)
9-pin, female)
The monitor can be operated according to control
commands sent from connected external equipment.

(DC 26 V input) connector (LMD-X310MT
only)
Connects the DC connector of the supplied AC adaptor.
Caution
Connect the DC connector to the unit, then connect the
power cord of the AC adaptor.
To remove the DC connector, remove the power cord of
the AC adaptor, then remove the DC connector.
WARNING
For the DC power supply, make sure to use the supplied
AC adapter, AC-300MD.
If another power supply is used, there is a risk of fire or
electric shock.

(equipotential) terminal
Connects the equipotential plug.
  (AC input) connector (LMD-X550MT only)
Connects the supplied AC power cord.
Caution
Do not come into contact with the terminals of the rear
panel connectors and patients at the same time.
Doing so may result in a generation of voltage that can be
harmful to patients if the unit is malfunctioning.
Always disconnect the power cord before connecting
and disconnecting connectors.
Location and Function of Parts and Controls
19