Before You Use - Elmo PX-10 Instruction Manual

BEFORE YOU USE

■ The supplied power cord and AC adapter are designed for exclusive use with this product.
Do not use them with other products.
■ Be sure to use the power cord applicable to your local power specifications. If the product
was sold in Japan, use the AC adapter sold with the product with 100 VAC and 50 or 60 Hz.
■ When storing the product, do not leave it under direct sunlight or by heaters. It may be
discolored, deformed, or damaged.
■ Do not place this product in any humid, dusty, salt bearing wind, or vibrating locations.
Use it under the following environmental conditions:
Temperature：0℃～ 40℃
■ Do not put your finger between the arms when moving the arm. You may pinch your finger
and result in injury.
It is recommended to attach the supplied caution sticker to the product.
■ Use a soft, dry cloth for cleaning.
Do not use any volatile solvent such as thinner or benzene.
■ Do not point the lens directly to the sun. It could degrade the imaging capability.
■ Luminescent and Black Spots
There may be some pixels that do not properly operate due to the use of CMOS Area
Image Sensors made-up of many pixels.
Though luminescent or black spots may be found on the screen, it is a phenomenon
peculiar to the CMOS Area Image Sensors and is not a malfunction.
■ A protection sheet is attached to the touchscreen at the factory to avoid damage during
transportation. Remove the sheet before use.
Do not strongly press the touchscreen or press it with sharp objects. This may result in
damage or malfunction to the touchscreen.
■ Follow the guidelines below to prevent the unit from dropping or overturning.
・ Use the product on a stable base, desk, or table. Do not place the product on an
unstable base or slanted location.
・ Place or wire the product so as to prevent the cables from being pulled or drawn.
■ Never hold the product by the arm or the camera head. Carry the product by holding the
lower part of the main unit in both hands after folding the arm and the camera head.
■ Pay careful attention when using (including setting-up and storing) or carrying the product
to prevent the camera head from receiving any shocks.
■ After folding the product, do not place heavy object on the arm.
■ Do not look directly into the LED light. If you look directly into it at pointblank range, your
eyes may be injured.
■ The LED may get hot after using it for long hours. Do not touch it directly.
It is recommended to attach the supplied caution sticker to the product.
■ Depending on the type of the SD card or USB flash drive, it may not be used with the
product.
■ Transfer the data from the SD card or USB flash drive onto a device such as a PC to save
a backup copy.Malfunction of the product or repairs to it may cause the data saved in the
SD card or USB flash drive to be deleted.
■ If this product is used for longer than the warranty period, its performance and quality
may deteriorate due to the lifetime of its parts. For parts replacement (on chargeable
basis), consult the dealer from whom you purchased this product or our branch/office near
your location.
■ Battery precautions:
・ Remove the battery from the remote control when not in use for an extended period of
time.
・ Do not use a rechargeable battery.
・ Do not charge or short-circuit the battery.
・ Follow the regulations of the city or town when disposing of the battery.
Humidity：30％～ 85％(No condensation)
6