Rear Panel - Elmo PX-10 Instruction Manual

CAUTION
The touchscreen is made of glass. Pay attention to the followings to avoid glass breakage and injury.
• Do not rub or press the touchscreen with a sharp object such as a knife.
• Do not press the touchscreen strongly by finger or do not apply weight to the touchscreen.
• Do not rub the touchscreen with a hard object.
• Do not hit the touchscreen with a hard object or do not drop it onto the touchscreen.
• Do not put an object on the touchscreen.
• Gently wipe the surface with a soft cloth to remove dirt.
Pay attention to the followings in order to maintain the performance of the touchscreen.
• Do not stick adhesive tape on the touchscreen.
• A protective sheet is attached to the surface of the touchscreen to avoid scratches during transportation.
Remove the sheet gently before use.

◆REAR PANEL

① ②
Name
①
DC IN 12V
②
RS-232C
HDMI in 1
③
HDMI in 2
④
RGB in
LAN
⑤
(for PX-30
only )
HDBaseT
⑥
(for PX-30
only)
⑦
RGB out
⑧
USB3.0B
⑨
DC OUT 5V
⑩
HDMI out
※１ The maximum transmit distance for 4K video signals at 30fps will be 70m when using the cat 5e LAN cable.
The maximum transmit distance for video signals of less than 1080 resolution will be 100m when using the
cat 5e LAN cable.
The maximum transmit distance for 4K video signals at 30fps will be 100m when using the cat 6a (or higher)
LAN cable.
※２ The maximum current available from the ⑨[DC OUT 5V] port in the rear panel and the ②[USB2.0] port in
the side panel is 1.2[A] in total.
For PX-30 only
③ ④ ⑤
To connect the DC plug of the supplied AC adapter. （DC12V）
To connect the RS-232C cable (commercially available) to control the PX-10/30
from a PC.
To connect the HDMI cable (commercially available) to input HDMI images and
audio. [HDMI TYPE-A]
To connect the RGB cable (commercially available) to input analog RGB images.
[mini DSUB15pin]
To connect the LAN cable (commercially available) to control the PX-10/30 from a
PC or transfer images over the network. [RJ45]
To connect the LAN cable (commercially available) to connect the PX-30 and a
device which has the HDBaseT port. [RJ45] ※１
To output RGB images. [mini DSUB15pin]
To connect the USB cable compliant to USB3.0 (super speed USB) to connect the
PX-10/30 and a device which supports USB3.0. [USB Standard-B （USB device）]
※ USB 2.0 cable can also be connected.
To supply power to other devices. Use this port for connecting a WHDI dongle or
charging a tablet. [USB TYPE-A （USB power supply）] ※２
To output HDMI images and audio. [HDMI TYPE-A （HDMI1.4 compliant）]
⑥ ⑦ ⑧ ⑨
Function
14
⑩