➎ Trouble Shooting - Elmo PX-10 Instruction Manual

➎ TROUBLE SHOOTING
◆ SYMPTOMS AND CONFIRMATION
Check the following items. If any abnormality is found, consult the dealer from whom you
purchased the PX-10/30 or our nearest branch/office.
Symptom
No image is displayed.
The output image
(resolution) changes
automatically.
No image is displayed
from the USB port.
The image is out of
focus
The image is too dark.
The image is striped.
Images on the SD
card/USB flash drive
are not displayed.
The image does not
move.
Not possible to operate
with the Remote
control.
Possible cause/ remedy
・The cable is not correctly connected.
・The AC power cord is disconnected from the wall outlet.
・The AC adapter is disconnected from the power inlet of the PX-10/30.（⇒P.20）
・The power is not on. (Power button: lit in blue)
・If you turn on the power immediately after turning it off, the PX-10/30 may not start.
Wait for several seconds after turning the power off, and then turn it back on.
・Reconnect the AC power cord.
・Zoom is set to the TELE side, displaying only the white or black part of the
document.（⇒P.21）
・Wrong input source is selected. Set the correct input source from the Select image
menu.（⇒P.26）
・The output resolution setting of the connected monitor or projector does not match
that of the PX-10/30. Check the output resolution setting of the monitor or
projector.（⇒P.27）
・The resolution setting is set to Auto. When the resolution setting is set to Auto, the
output resolution is automatically changed based on the information from the
connected device.（⇒P.27）
・No image will be output from the USB port when the USB mode is set to "Mass
storage (file transfer)". Check the USB mode and select "UVC (image output)" from
the System Setting.（⇒P.28）
・NThe document (subject) is too close to the lens. Move the document (subject)
slightly away from the lens.
・The intensity of the lighting is insufficient. Turn on the LED lighting with the
Brightness button in the operating panel or adjust the Iris. （⇒P.22、P.23）
・Press the [
/
・This may be interference fringes between dots of printed matter and TV scanning
lines or CMOS pixels. Changing the shooting range may improve the problem.
・Vertical stripes may appear on an LCD projector image. Manually adjusting the dot
clock at the projector side may help the problem.
・Remove the SD card/USB flash drive, wait for a few seconds, and insert again.
（⇒P.15）
・"Freeze" function is used. Press the Freeze button [
[ ] on the remote control to restart the live image feed.（⇒P.13、17）
・The remaining battery level of the remote control is low. Replace the battery with a
new one.
・Wrong remote control is used. Use the supplied remote control.（⇒P.17）
] buttons on the remote control to adjust the brightness.
45
] on the operating panel or