Table of Contents
Advertisement
New functions in firmware version 1.30
The following new functions have been added in firmware version 1.30.
0 DA-6400 Control iPad remote control app support added
0 TASCAM IF-AE16 AES/EBU interface card support added
0 Function added to synchronize with SMPTE timecode and play the current take
0 VAMPING mode added to repeat playback function modes
0 Function added to set the input and output signal routing for each individual channel
0 On/off setting added for NO SIGNAL error checking function
0 Function added that requires pressing and holding the button to stop recording
TASCAM DA-6400 Control iPad remote control app support added
The TASCAM DA-6400 Control iPad remote control app is now supported.
TASCAM IF-AE16 AES/EBU interface card support added
The TASCAM IF-AE16 AES/EBU interface card is now supported.
If installed in SLOT 1 or SLOT 2 of this unit, the following appears
on the
or
menu page.
SLOT1
SLOT2
CLOCK LINE
If the slot with the IF-AE16 card installed is selected to be the
clock master for the unit, this selects the signal line to use as
the clock master.
Options:
(default),
AES 1-2
,
AES 7-8
AES 9-10
,
AES 13-14
28
TASCAM DA-6400/DA-6400dp
DA-6400/DA-6400dp
,
,
AES 3-4
AES 5-6
,
,
AES 11-12
AES 15-16
NOTE
i When the slot with the IF-AE16 card installed is selected to be
the clock master, you can also set the
the
screen that opens from the
CLOCK
item. Moreover, if the slot with the IF-AE16 installed
MASTER
is selected to be the clock master, you can also change the set-
ting by moving the cursor to
JOG dial.
i If the
item is set to
SRC
ON
lected as the master clock In this case, the following pop-up
window appears. A confirmation pop-up message appears.A
confirmation pop-up message appears.
item on
CLOCK LINE
page
GENERAL
CLOCK
and pressing the MULTI
APPLY
for a signal line, it cannot be se-
Advertisement
Table of Contents
