On/Off Setting Added For No Signal Error Checking Function; Function Added That Requires Pressing And Holding The Button To Stop Recording - Tascam DA-6400 Manual

On/off setting added for NO SIGNAL error checking function

We have added a setting that stops the "
appearing so you can use the main unit without inputting an
audio signal (when using it as a dedicated playback device, for
example).
A
NO SIGNAL ERROR CHECK
menu page. It allows the
PREFERENCES
firmation function to be turned on/off.
PREFERENCES
NO SIGNAL ERROR CHECK

Function added that requires pressing and holding the button to stop recording

In order to prevent recording failures due to misoperation, a
function has been added that requires pressing and holding the
button to stop recording.
Use the
REC STOP/PAUSE MODE
menu page to set the press and hold to stop recording function.
REC OPTIONS
REC STOP/PAUSE MODE
Options
(default):
NORMAL
Press the 8 or 9 [CHASE] button during recording to
stop or pause recording immediately.
:
HOLD
Press and hold the 8 or 9 [CHASE] button for three
seconds during recording to stop or pause recording.
If the 8 or 9 [CHASE] button is pressed for less than
three seconds, recording will continue and the follow-
ing message will appear.
DA-6400/DA-6400dp
" error from
no signal
item has been added to the
error con-
NO SIGNAL
page
screen
item on the
REC OPTIONS
page
screen
Options
(default value): When the unit determines that the input
ON
signal connection has been interrupted,
the INFO indicator lights red, and an
ERROR INFORMATION
SLOT1 has no signal
sage, for example, appears.
: Even when no audio input signal is connected, the
OFF
INFO indicator will not light red, and an
screen will not appear. Use this setting
FORMATION
when you want to use the main unit without input-
ting an audio signal (when using it as a dedicated
playback device, for example).
NOTE
This function only affects STOP/PAUSE operations from the
following control sources.
o Front panel
o USB keyboard
o Parallel connector
o Keyboard via VNC viewer
STOP/PAUSE commands from RS-422 or Telnet will stop or
pause recording regardless of the setting of this function.
TASCAM DA-6400/DA-6400dp
screen with a
error mes-
ERROR IN-
33