Table of Contents
Advertisement
NOTE
i The cascade status is also shown on the
i If the status is anything other than
screen appears with an error/alert as shown below.
INFORMATION
i If one of the above cascade errors occurs, recording/playback cannot be started.
i If one of the above cascade alerts occurs, recording/playback can be started. if the error is
cascade master unit will operate.
CASCADE UNITS
This shows the IDs of the cascade units recognized by this unit.
Check whether each device is operating with cascade synchronization by looking at its
Example when MASTER and SLAVE-1 devices are recognized:
M S1
Example when no devices are recognized:
NONE
CASCADE SETUP
Use this to set up the cascade function.
Select
, and press the MULTI JOG dial to open a screen where you can change the cascade function settings.
CASCADE SETUP
in the last line, press the MULTI JOG dial to confirm the changed settings and return to the Menu Screen.
When on
APPLY
Press the EXIT [PEAK CLEAR] button to cancel the menu operation and return to the Menu Screen.
CASCADE MODE
This sets the cascade operation mode.
Options
(default): This disables the cascade function.
OFF
: This enables the cascade function.
ON
CASCADE ID
This sets the cascade device ID.
The cascade ID should always be set to one not used by any other device.
Option
(default)
MASTER
SLAVE-01
DA-6400/DA-6400dp
screen.
INFORMATION
or
Cascade OFF
OK
screen
ERROR INFORMATION
Meaning
Sets this unit as the cascade master.
Sets this unit as cascade slave 1.
, the INFO indicator lights red, and an
ALERT INFORMATION
CASCADE STATUS
ERROR INFORMATION
screen
, then only the
Offline (No Slaves)
item.
TASCAM DA-6400/DA-6400dp
or
ALERT
3
Advertisement
Table of Contents
