Tascam DA-6400 Manual page 16

4.
Operations on the
START/END POINT
what different than on other screens.
Control assignments are shown at the top right of the screen.
When the frame cursor is visible, turn the MULTI JOG dial
1
to move the cursor.
 W hen the frame cursor is visible, press the MULTI JOG dial
2
to switch to the solid cursor.
 W hen the solid cursor is visible, press the MULTI JOG dial
3
to switch to the frame cursor.
 W hen the solid cursor is visible, turn the MULTI JOG dial
4
to change the setting at the cursor position.
Turn the MULTI JOG dial while pressing and holding the
SHIFT button to make large setting changes.
However, the solid cursor is always visible on
and . Turning the MULTI JOG dial will move
<<CURRENT
the cursor, and pressing the MULTI JOG dial will execute
the or
RESET>> <<CURRENT
With , press the MULTI JOG at the
RESET>>
to reset to the beginning of the take or at the
reset to the end of the take.
In either case, a confirmation pop-up message will appear
before resetting. Press the MULTI JOG dial to reset it.
, press the MULTI JOG dial to capture
With
<<CURRENT
the current playback position to a cursor line.
NOTE
Editing operations are also possible using a USB keyboard.
o Press the ENTER key to switch between the frame cursor
and solid cursor.
o Use the up and down cursor keys to change settings.
o Use the left and right cursor keys to move the cursor.
o Numbers can be input when the solid cursor is on a numer-
ical value.
16
TASCAM DA-6400/DA-6400dp
DA-6400/DA-6400dp
screen are some-
RESET>>
operation.
line
START
line to
END
Use transport operations on the
5
screen to conduct rehearsal playback.
o Use the . and / buttons to move between the
file start, the
Start Point
file end. Otherwise, transport operations are as usual.
o If you change the
Start Point
will move to that point. If it is changed during playback,
playback will continue after moving to this playback po-
sition.
o If you change the
End Point
will move to 2 seconds before that point. If it is changed
during playback, playback will continue after moving to
this playback position.
o Depending on the
PREVIEW
the screen, the content of rehearsal playback will be dif-
ferent.
Rehearsal playback when PREVIEW OFF
Press the 7 button to start playback from the cur-
rent position. Playback and movement are possible
outside the range between the
the .
End Point
Rehearsal playback when PREVIEW ON
Press the 7 button to start playback from the cur-
rent position. In this case, playback is only possible
inside the range between the
the . Movement outside this range is not
End Point
possible.
5.
When done editing, press the EXIT button to return to the
original screen.
Recording in Playlist Mode
Recording is possible even when using Playlist Mode.
When a take is recorded, it is automatically added as the next en-
try after the highest numbered entry that has an assigned take in
the current playlist.
Example:
Playlist before recording
Playlist after recording
NOTE
If a take has been assigned to entry 999, which is the last play-
list entry, pressing the 0 [SPLIT] button will cause the follow-
ing pop-up message to appear. Recording will not be possible.
START/END POINT
, the and the
End Point
, the playback position
, the playback position
setting at the top right of
and
Start Point
and
Start Point