Access To Control Terminals; Electrical Installation, Control Terminals - Danfoss FC 300 Instruction Manual

Hide thumbs Also See for FC 300:
Table of Contents

Advertisement

FC 300 Instruction Manual

Access to Control Terminals

"
All terminals to the control cables are located
underneath the terminal cover on the front of the
adjustable frequency drive. Remove the terminal
cover by means of a screwdriver (see illustration).

Electrical Installation, Control Terminals

"
To mount the cable to the terminal:
Strip isolation of 0.34-0.39 in [9-10 mm]
1.
Insert a screwdriver in the square hole.
2.
Insert the cable in the adjacent circular hole.
3.
Remove the screwdriver. The cable is now
4.
mounted to the terminal.
To remove the cable from the terminal:
1.
Insert a screwdriver in the square hole.
Pull out the cable.
2.
How to Install
A1, A2 and A3 enclosures
A5, B1 and B2 enclosures
MG.33.A6.22 - VLT is a registered Danfoss trademark
1.
2.
3.
23

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FC 300 and is the answer not in the manual?

Table of Contents