Replacing A Designer Color Filter - PRG BAD BOY 02.9812.0001C User Manual

B B ™ S L
AD OY POT UMINAIRE

Replacing a Designer Color Filter

Parts:
Designer Color Filter(s), as required
Tools and Supplies:
#2 Phillips screwdriver
Cotton gloves or finger cots
WARNING: Remove power from luminaire before performing any maintenance procedures.
To replace a designer color filter:
Step 1. Remove power from
luminaire.
Step 2. Locate appropriate head
cover door for access to
Designer Color Wheel as
shown in
page
identified by a label.) Turn
captive screw to open door.
CAUTION: Do not touch color
filters with bare fingers. Wear cotton
gloves or finger cots when handling.
Step 3. Rotate wheel until desired
designer color filter is
accessible.
Step 4. Rotate Color and Gobo 2
Wheels so that their "open"
position lines up next to the
designer color filter you
wish to replace. (This will
avoid potential damage to
the adjacent wheels as the
filter is being replaced.)
Step 5. Using fingers, grasp frame
of color filter and pull out of
wheel hub
Step 6. Noting proper orientation of
carrier, insert new designer
color filter into position and
push until carrier clicks into place. Refer to
designer filter positions.
7 6
U M
SER ANUAL
Figure 4-10 on
73. (Doors are
(Figure 4-13).
3
4
5
Wheel Hub
6
Note : Drawing is flipped 180°
for clarity purposes.
Figure 4-13: Replacing a Designer Color Filter
Figure 4-14
Designer Color Filter
Carrier
2
1
Open Hole (no filter)
7
on next page for an overview of
02.9812.0001C