Cleaning The Enclosure Intake Filters - PRG BAD BOY 02.9812.0001C User Manual

B B ™ S L
AD OY POT UMINAIRE

Cleaning the Enclosure Intake Filters

The intake filters should be cleaned or replaced when they are dirty. The frequency will depend on how
often and in what conditions the luminaire is used.
Tools and Supplies:
#2 Phillips screwdriver
Compressed air and/or water
To clean enclosure intake filters:
WARNING: Remove power from luminaire before performing any maintenance procedures.
Step 1. Remove power from luminaire.
Step 2. Remove Intake Cover by first loosening two captive screws, then pulling away from Upper
Enclosure as shown in
Upper Enclosure
Step 3. At retainer, remove four 6-32 x 1/2" PPZ screws.
Step 4. Remove intake filter.
Step 5. Clean filter with compressed air and/or by washing with water.
Step 6. Re-install components.
Step 7. Repeat for second intake filter.
6 4
U M
SER ANUAL
Figure 4-5.
Intake Cover
Figure 4-5: Removing Enclosure Intake Filters
Parts:
40-9812-0834 2 EA AIR INTAKE FILTER
Mesh Cover
Intake Filter
Retainer
6-32 x 1/2"
PPZ Screw (4)
Intake Filter
NOTE:
If the filters do not get clean after multiple
attempts, they should be replaced.
Captive Screws
02.9812.0001C