Standing Position - PRG BAD BOY 02.9812.0001C User Manual

B B ™ S L
AD OY POT UMINAIRE

Standing Position

The Bad Boy™ Spot Luminaire can also be used in a standing position. Be sure that the floor or stage
will accommodate the load of this moving luminaire.
To install in a standing position:
Step 1. Unlatch and remove case lid
Step 2. Remove Power Cord and Safety Cables from case.
Step 3. Tilt case upright as shown. Use grips on bottom of case to assist in tilting upward.
Step 4. Carefully remove luminaire from case and place in standing position.
Step 5. Connect power and data cables according to
Case
Grips
2
1 8
U M
SER ANUAL
(Figure
1
Power Cord and
Safety Cables
Figure 2-8: Standing Position
2-8).
"Connecting Power and Data"
Case
3
on page 19.
4
02.9812.0001C