Setting A Starting Address; Dmx Comm - PRG BAD BOY 02.9812.0001C User Manual

2
I : P U B S P
NSTALLATION OWER P AND ASIC ETUP ROCEDURES

Setting a Starting Address

The method for setting a DMX starting address is the same whether the luminaire is being controlled
by DMX512 or Ethernet (Art-Net). The only difference is that the Home screen will display the Comm
as either "DMX" or "ETH" depending on the control input.
The DMX starting address is programmed at the Menu Touchscreen. The luminaire retains its address
even if power is removed.
Note: Refer to your console operating instructions for specific information regarding its addressing
requirements.

DMX Comm

The starting address for DMX512 systems is programmed using the CONFIG menu.
To program a starting address:
Step 1. At Home screen, press CONFIG panel.
Step 2. At Configuration screen, press DMX ADDRESS panel.
Step 3. At numeric keypad, enter new starting address and press ENTER.
Control Input Type
Figure 2-13: Setting Starting Address (DMX Control)
Note: Refer to "Menu System" on page 30 for more information about the Menu Touchscreen.
23
0 2. 9 8 1 2. 0 0 01 C