Replacing A Gobo - PRG BAD BOY 02.9812.0001C User Manual

Replacing a Gobo

Parts:
Standard or Custom Gobo(s), as required
Tools and Supplies:
#2 Phillips screwdriver
Cotton gloves or finger cots
WARNING: Remove power from luminaire before performing any maintenance procedures.
To replace a gobo:
Step 1. Remove power from luminaire.
Step 2. Locate appropriate head cover door for access to Rotating Gobo Wheel 1 (R1) or Rotating
Gobo Wheel 2 (R2) as shown in
screw to open door.
CAUTION: Do not touch gobos with bare fingers. Wear cotton gloves or finger cots when handling.
Step 3. Rotate wheel until desired gobo is accessible.
Step 4. Rotate Color Wheels so that their "open" position lines up next to the gobo you wish to
replace. (This will avoid potential damage to the adjacent wheels as the gobo is being
replaced.)
Captive Screw
Head Cover Door
R1 Wheel Access
0 2. 9 8 1 2. 0 0 01 C
T
ROUBLESHOOTING AND
Head Cover Door
R2 and Designer Wheel Access
Z
Figure 4-10: Accessing Gobo and Designer Color Wheels
M : R
AINTENANCE
Figure 4-10. (Doors are identified by a label.) Turn captive
Captive Screw
M
OUTINE AINTENANCE
X
4
73