Table of Contents
Advertisement
INSTALLATION
3: Attach Tensioning Tool
Thread free end through
both jaws of tension tool.
Tighten the tension on the
band using the tension tool.
NOTE: Do not
over-torque bands on
cast aluminum antenna base.
4: Cut Excess
Raise the tension tool to
bend the band back over the
buckle.
Pull the cutoff lever and
cut off the excess banding
material.
5: Secure Buckle
Secure the buckle. Bend
the end of the band down
by lightly tapping with a
hammer. Using a hammer,
bend the two locking tabs
over the end of the band.
CD52 Bandit (ATEX-IECEx Certification) User Guide
Page 30 of 48
Advertisement
Table of Contents
