SETUP & OPERATION
User Board Jumper Settings
The CD52 Bandit user board contains a jumper block which has
been factory set for battery or 24 VDC power source, depending on
specification at time of order. If power source is to be changed (for
example, if your CD52 was ordered and shipped as a 24 VDC-powered unit
and you desire instead to operate it with batteries), you must re-set the
jumper as shown:*
Board Settings for Battery Power
NOTE: Set jumper before installing batteries.
Set jumper to Pin 1.
*4-20mA Current Loop Interface models are pre-set for 24 VDC power and
cannot be reconfigured for battery operation.
CD52 Bandit (ATEX-IECEx Certification) User Guide
Page 10 of 48