Table of Contents
Advertisement
1: Prep Banding
Prepare the band and buckle.
Slide the buckle over the band
and crimp in place.
NOTE: The banding
material and band tension
tool* are stocked by CDI.
2: Attach Base
Set the base on the pipeline. Loop the free end of the band through the
slots at one end of the base.
Continue looping the free end
around the pipe until it meets
the buckle at the other end of
the band.
NOTE: The standard CD52
antenna base (shown here)
is of cast aluminum and must be
handled with care. Do not over-
torque bands.
If needed, use electrical insulators (see pg. 33) to prevent interference
with cathodic rectifiers.
Slide the free end of the band
through the buckle.
*CDI Part # 81–04–0008–00
CD52 Bandit (ATEX-IECEx Certification) User Guide
Page 29 of 48
INSTALLATION
Advertisement
Table of Contents
