Table of Contents
Advertisement
The Bandit is now prepared to set the hour portion of the clock. To
change the hour, simply rotate the lever to the activate position and hold
it there. You should notice the BTN segment lights and the hour digits
begins to increase at a rate of one hour per second.
Continuing to hold the lever in the activated position will cause the hours
to increase until they reach "12", and then wrap to "1" (The Bandit uses
12-hour, not 24-hour time).
Hold the lever in the activated position until the digit reaches the desired
hour and then release. The display will jump to the minute portion of the
time to set. The same method is used to set the minutes. Simply press
and hold the lever to increment the digits, and release to move to the
date.
Repeatedly pressing and releasing the lever while in clock set mode
causes the unit to cycle through the following clock set options:
1. HOURS
2. MINUTES
3. AM/PM
4. DAY
5. MONTH
Portable Models
The portable Bandit is designed for temporary location/relocation from
one tracking site to the next. It is identical to standard units in function
and operation, with two notable exceptions:
•
Battery power only
•
Suspend Mode push button
The Suspend Mode button is located on the back.
When pressed, all Bandit functions are paused to
prevent inadvertent triggering of the unit during
repositioning. The Active Function Indicator LCD (pg. 16)
will alternate between F1 and F2 every second.
CD52 Bandit (ATEX-IECEx Certification) User Guide
To end the clock set mode, simply
release the lever. Normal Bandit
operation will return in twenty-five
(25) seconds and the clock will be set
to the time indicated.
Page 27 of 48
SETUP & OPERATION
Advertisement
Table of Contents
