Mask And Tubing Setup - ResMed H5i Clinical Manual

Mask and tubing setup

• For more information on assembling the mask see the mask user guide.
• If your patient is using a full face mask ensure that the "Full Face" setting is selected. If your patient
is using a nasal pillows mask ensure that the "Pillows" setting is selected. If your patient is using a
nasal mask ensure that the "Nasal" setting is selected with the exception of the Ultra Mirage mask
which should use the "Nasal Ultra" setting.
• For a complete list of recommended masks and their settings go to www.resmed.com on the
Products page under Service & Support. If you do not have internet access, please contact your
ResMed representative.
• The VPAP Adapt device is compatible with the following tubing:
Tube
ClimateLine
ClimateLine
MAX
SlimLine
Standard
3 m
Note: When using the SlimLine or ClimateLine above 20 cm H
may not be reached if used with an antibacterial filter. The device performance must be checked prior
to prescribing the SlimLine for use with an antibacterial filter.
8
Specifications
Heated
Length: 6'6" (2 m)
Inner diameter: 0.6" (15 mm)
Heated
Length: 6'3" (1.9 m)
Inner diameter: 0.75" (19 mm)
Length: 6' (1.8 m)
Inner diameter: 0.6" (15 mm)
Length: 6'6" (2 m)
Inner diameter: 0.75" (19 mm)
Length: 9'10" (3 m)
Inner diameter: 0.75" (19 mm)
Settings
Automatically detected
Automatically detected
If using the SlimLine, Standard or 3 m
tubing, adjust the tube setting in the
Patient Setup or Clinical Setup menus.
O, the device optimum performance
2