System Setup - ResMed H4i User Manual

System Setup

1
Align your H4i with your flow generator and push them together until they click into
place.
2
Connect the power cord to the socket on the rear of your flow generator.
3
Plug the other end of the power cord into the power outlet.
Place the combined unit on a firm, level surface near your bed at a level lower than
your sleeping position. Ensure the surface is not sensitive to heat and/or moisture, or
use a protective mat.
4
Connect one end of the air tubing firmly onto the air outlet.
5
Connect the assembled mask system to the free end of air tubing.
WARNING
!
Make sure your flow generator is switched off at the power outlet before
•
connecting the H4i.
The H4i docking station should only be connected or disconnected when the
•
water chamber is empty.
Water must be prevented from entering your flow generator. Do not
•
transport the flow generator with the H4i attached.
2
2
1
3
4
5