52
Operation
Sharing Content
If you want to share contents and camera video to far end site device by the real time during a call, the far end site have to support H.239. And
you should set to H.323 on the [Setup>User>General>Outgoing Protocol].
1. Follow steps 1-2 described in "Changing the Video Source".
2. Press PRESENTATION.
3. You can select the type of sharing contents using by the Second Display option on the [Setup>User>General>Second Display].
•
If you set to Second display option to OFF, content and Main Camera screen will be displayed in one monitor (or TV).
4
•
If you set to Second display option to ON, Content and Main Camera screen will be displayed on two monitors (or TV) connected to
each HDMI Port separately. The screen shows below table as the "Video Source Setting" of near end camera.
Video Source Setting
Main Camera 1
VGA Input
NOTE
•
This unit supports 640 x 480, 800 x 600, 1 024 x 768, 1 280 x 720, 1 280 x 768, 1 280 x 1 024, 1 400 x 1 050 and 1 920 x 1 080 and 60Hz for
PC output resolutions.
•
If the PC screen can not see properly after D-sub cable insert or remove from the VCS, check the PC video output connection again .
HDMI OUT 1
Camera Screen
Contents Screen
HDMI OUT 1
HDMI OUT 2
Contents Screen
Camera Screen
HDMI OUT 2