Installing A Fabric Card - Cisco NCS 4016 Installation Manual

Installing a Fabric Card

Required Tools and Equipment
ESD-preventive wrist strap
•
Number-2 Phillips screwdriver or number-2 common (flat-head) screwdriver
•
FC (Cisco PID NCS4016-FC-M)
•
Steps
The following steps describe how to install an FC card.
Figure 5-4
Step 1 Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the two ESD jacks
located on the front or rear side of the chassis. You can also connect the ESD-preventive wrist strap leash
to any bare metal surface on the chassis.
Cisco Network Convergence System 4000 Series Hardware Installation Guide
5-12
Chapter 5
Installing an FC
Installing Route Processor Cards, Fabric Cards, and Line Cards