Removing A Filler Card; About Rp Cards; Installing An Rp Card - Cisco NCS 4016 Installation Manual
Network convergence system ncs 4000 series
Hide thumbs
Also See for NCS 4016:
- Manual (24 pages) ,
- Unpacking and installing (8 pages) ,
- Hardware installation manual (82 pages)
Table of Contents
Advertisement
Chapter 5
Installing Route Processor Cards, Fabric Cards, and Line Cards
Removing a Filler Card
This section describes how to remove a filler card from the Cisco NCS 4016 chassis.
Prerequisites
Before performing this task, open the front door, if installed.
Required Tools and Equipment
•
Steps
The following steps describe how to remove a filler card.
Identify the filler card to be removed from the card cage. Use the number-2 Phillips screwdriver or
Step 1
number-2 common (flat-head) screwdriver, and turn the two captive screws on the front panel of the card
counterclockwise to loosen the card from the slot.
Step 2
Grasp the filler card handle with one hand and gently pull it halfway from the slot.
Step 3
Place one hand under the filler card to guide it.
Step 4
Holding the filler card underneath and by the handle, pull it from the slot, and set it carefully aside.
About RP Cards
The Cisco NCS 4016 chassis supports two route processors (RPs). These cards provide the intelligence
of the system by functioning as the shelf controllers for DWDM or OTN applications and by providing
route processing and chassis management. The RP cards also monitor system alarms and control the
system fans. LEDs on the front panel indicate active alarm conditions.
Two RPs per chassis are required for a redundant system. RP cards are inserted into the two dedicated
slots in the chassis, located on the top and bottom right in the card cage.
See the
about LEDs, troubleshooting, and the front panel of the RP card.
Physical Characteristics
•
•
•
•
Installing an RP Card
This section contains the following procedures:
•
Number-2 Phillips screwdriver or number-2 common (flat-head) screwdriver
"Verifying and Troubleshooting the Installation of an RP Card" section on page 5-9
Height—11.05 in. (280.6 mm)
Width—1.55 in. (39.4 mm)
Depth—14.25 in. (362 mm)
Weight—7.32 lb (3.32 kg)
Installing an RP Card, page 5-6
Cisco Network Convergence System 4000 Series Hardware Installation Guide
About RP Cards
for details
5-5
Advertisement
Table of Contents
Troubleshooting
