Connecting Power To The Chassis; Connecting Power To An Ac-Powered Chassis - Cisco NCS 4016 Installation Manual
Network convergence system ncs 4000 series
Hide thumbs
Also See for NCS 4016:
- Manual (24 pages) ,
- Unpacking and installing (8 pages) ,
- Hardware installation manual (82 pages)
Table of Contents
Advertisement
Chapter 4
Installing Power Components
Figure 4-18
1
Connecting Power to the Chassis
Use one of the following procedures to connect power to your chassis:
•
•
Connecting Power to an AC-Powered Chassis
Follow these steps to connect the AC power cords to the chassis.
Connect each AC power supply to a dedicated power source (branch circuit). Each AC input power
Note
supply operates at a nominal input level of 200 to 240 VAC.
Connecting Power Cables to Terminal Blocks
Terminal Blocks
Connecting Power to an AC-Powered Chassis, page 4-23
Connecting Power to a DC-Powered Chassis, page 4-25
Cisco Network Convergence System 4000 Series Hardware Installation Guide
Connecting Power to the Chassis
4-23
Advertisement
Table of Contents
Troubleshooting
