Intrusion - Digital Watchdog MegaPix DWC-MVT4WiA User Manual

7.5.4 Intrusion

Intrusion: Alarms will be triggered if someone or something intrudes into the pre-
defined areas. This function can be applicable to important supervision places,
danger areas and prohibited areas, like military administrative zones, house
breaking, scenic high danger areas, no man's areas, etc.
Go to Config Event
→
1. Enable region intrusion detection alarm and set the alarm holding time.
2. Set alarm trigger options. The setup steps are the same as motion detection.
Please refer to motion detection chapter for details.
3. Click the "Save" button to save the settings.
4. Set the alarm area of the intrusion detection. Click the "Area" tab to go to the
interface as shown below.
Intrusion interface as shown below.
→
36
The ground is covered
with vegetation; at the
right of the fence is a gym
where people pass by
frequently. The above
mentioned environment is
too complex to detect the
crossing objects.