Table of Contents
Advertisement
5.
Set the schedule of the crowd density detection. The setup steps of the schedule
are the same as schedule recording setup (See
※Configuration of camera and surrounding area
1. The lens direction of the camera shall be the same as people flow, allowed a little
bit incline. The direction of the people flow shall be less than 45°from the horizontal. It
is recommended that the angle between the lens of the camera and the floor shall be
between 30° and 60°.
2. The size of a single person of the people flow shall take up between 1% and 5% of
the entire image and the height of the figure occupies from 1/5 to 1/2 of the entire
image.
3. This function is inapplicable to the scene where there are many moving objects
except human shape, like moving car.
4. Abundant trees and billboards are not allowed in the detected area.
7.5.6 People Intrusion
This function is specially designed for the use of indoor scenes. To prevent someone
from intruding indoor to endanger the family security, alarms will be triggered if
someone enters into the detection area in 3~5s. The setup steps are as follows.
1.
Go to Config→Event→People Intrusion. Please refer to the following picture.
2.
Enable the people intrusion detection.
3.
Set "Alarm Sensitivity" and "Alarm Holding Time".
4.
Set alarm trigger options. The setup steps are the same as motion detection
setup. Please refer to
5.
Set the schedule of the people intrusion detection. The setup steps of the
schedule are the same as schedule recording setup (See
motion detection
chapter for details.
Schedule
Recording).
Schedule
40
Recording).
Advertisement
Table of Contents
