Digital Watchdog MegaPix DWC-MVT4WiA User Manual page 43

Click "Draw Area" and drag the mouse to draw a rectangle area. Drag the four
boundary lines of the rectangle to modify its size and move the rectangle to change its
position. Click "Stop Draw" to stop drawing the area. Click "Clear" to clear the area.
Click and drag the arrow or the other end of the arrow line to change the people
entrancing direction.
The detected area must be larger than the width of the main hallway of the people flow
(hereinafter referred to as "hallway"), reserved a certain distance from the edge of the
picture (the width of the undetected areas shall occupy 4%~10% of the whole picture).
The direction of detection shall be in conformity to the direction of the hallway as shown
in the picture above. The area drawn yellow box is the detected area. The head size
of the figure (width or height) shall account for 1/5 ~ 1/2 of the drawn detection area.
The direction along with the red arrow is entrance direction and the opposite direction
of the red arrow is exiting/departing direction.
After the people counting detection is successfully set up, the counting results will be
seen by clicking "Live" tab. Please refer to the following picture.
※ Configuration requirements of camera and surrounding area
1. Cameras must be installed in the area with stable and adequate light sources.
43