Alarm In - Digital Watchdog MegaPix DWC-MVT4WiA User Manual

2. Click "Enable alarm" and set the alarm holding time.
3. Trigger alarm out. When the camera is disconnected, the system will trigger the
alarm out.

7.4.3 Alarm In

This function is only available for some models. To set sensor alarm (alarm in):
Go to Config→Alarm→Alarm In interface as shown below.
1. Click "Enable alarm" and set the alarm type, alarm holding time and sensor name.
2. Set alarm trigger options. The setup steps are the same as motion detection.
Please refer to motion detection chapter for details.
3. Click "Save" button to save the settings.
4. Set the schedule of the sensor alarm. The setup steps of the schedule are the
same as the schedule recording setup. (See Schedule Recording).
28