Perimeter Intrusion - Digital Watchdog MEGApix DWC-MVT4Wi28 User Manual

6.5.3 Perimeter Intrusion

Perimeter Intrusion: Alarms will be triggered if someone or something intrudes into
the pre-defined areas. This function can be applicable to important supervision
places, danger areas and prohibited areas, like military administrative zones, house
breaking, scenic high danger areas, no man's areas, etc.
Go to Config > Event > Intrusion interface as shown below.
1. Enable perimeter intrusion detection alarm and set the alarm holding time.
2. Set alarm trigger options. The setup steps are the same as motion detection.
Please refer to motion detection chapter for details.
3. Click the "Save" button to save the settings.
4. Set the alarm area of the intrusion detection. Click the "Area" tab to go to the
interface as shown below.
33
The ground is covered
with vegetation; at the
right of the fence is a
gym where people pass
by frequently. The
above mentioned
environment is too
complex to detect the
crossing objects.