Digital Watchdog MegaPix DWC-MVT4WiA User Manual page 27

2. Click "Enable alarm" and set the alarm holding time.
3. Set alarm trigger options. The setup steps are the same as motion detection.
Please refer to motion detection chapter for details.
⚫ SD Card Error
When there are some errors in writing SD card, the corresponding alarms will be
triggered.
1. Go to Config Alarm
→
2. Click "Enable alarm" and set the alarm holding time.
3. Set alarm trigger options. Trigger alarm out, Email and FTP. The setup steps are
the same as motion detection. Please refer to
Note: SD card full and SD card error are only available for the models with SD slot.
⚫ IP Address Conflict
1. Go to Config Alarm
→
2. Click "Enable alarm" and set the alarm holding time.
3. Trigger alarm out. When the IP address of the camera is in conflict with the IP
address of other devices, the system will trigger the alarm out.
⚫ Cable Disconnection
1. Go to Config Alarm
→
Anomaly SD Card Error as shown below.
→ →
Anomaly IP Address Collision as shown below.
→ →
Anomaly Cable Disconnected as shown below.
→ →
motion detection
27
chapter for details.