Advanced Settings Page Definitions; Table 8: Advanced Settings - Grandstream Networks HT818 Administration Manual

Advanced Settings Page Definitions

Advanced Settings
New Admin
Defines the administrator level password to access the Advanced Web Configuration
Password
page.
This field is case sensitive. Only the administrator can configure the "Advanced
Settings" page. Password field is purposely left blank for security reasons after clicking
update and saved.
The maximum password length is 30 characters.
Confirm Admin Re-enter the admin password to confirm change admin password on web GUI to avoid
Password typo or mistakes.
Layer 2 QoS
Sets values for:
802.1Q/VLAN Tag. Default is 0. Valid range is 0-4094.
SIP 802.1p. Default is 0. Valid range is 0-7.
RTP 802.1p. Default is 0. Valid range is 0-7.
STUN Server
Configures IP address or domain name of STUN server. Only non-symmetric NAT
routers work with STUN.
Keep-alive interval Sends periodically a blank UDP packet to SIP server in order to keep the "ping hole" on
the NAT router open. Default is 20 seconds.
Use STUN to Uses STUN keep-alive to detect WAN side network problems. If keep-alive request does
detect network not yield any response for configured number of times (minimum 3), the device will
connectivity restart the TCP/IP stack. If the STUN server does not respond when the device boots
up, the feature is disabled. Default setting is No.
Use DNS to detect Uses DNS to detect WAN side network problems. Default setting is No.
network
connectivity
Verify host when Enables / disables the host verification when using HTTPS.
using HTTPS
Firmware upgrade
Selects firmware upgrade/provisioning method: TFTP, HTTP or HTTPS.
and provisioning
Sets IP address or domain name of firmware server. The URL of the server that hosts
Firmware Server
the firmware release. Default is fm.grandstream.com/gs
Path

Table 8: Advanced Settings

HT818 Administration Guide
Version 1.0.9.3
P a g e |
27