Advanced User Configuration - Grandstream Networks HT701 User Manual

Port Status

Advanced User Configuration

Log in to the advanced user configuration page the same way as for the basic configuration page.
password is case sensitive and the factory default password for Advanced User is "admin".
Advanced User configuration includes the end user configuration and the advanced configurations
including: a) SIP configuration, b) Codec selection, c) NAT Traversal Setting and d) other miscellaneous
configuration. HT701 and HT702 FXS SIP account(s) have its own configuration page. HT704 has two (2)
profiles for the four (4) FXS ports.
Table 10: Advanced Settings
Admin Password
Layer 3 QoS
Layer 2 QoS
STUN Server
Keep-alive interval
Use STUN to detect
network connectivity
Firmware Upgrade
and Provisioning
Grandstream Networks, Inc.
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Displays relevant information regarding the FXS port.
Port Hook Registration
FXS On Hook Registered
• FXS port is registered with SIP Server.
• FXS Port user has set Do Not Disturb.
• FXS Port user has set his calls to be unconditionally forwarded to ext 613.
• FXS Port user has not set Busy or Delay call Forward.
This contains the password to access the Advanced Web Configuration page. This field is
case sensitive. Only the administrator can configure the "Advanced Settings" page.
Password field is purposely left blank for security reasons after clicking update and saved.
The maximum password length is 25 characters.
This field defines the layer 3 QoS parameter which can be the value used for IP
Precedence or Diff-Serv or MPLS. Default value is 48.
Value used for layer 2 VLAN tag. Default setting is blank.
IP address or Domain name of the STUN server.
This parameter specifies how often the HT70X sends a blank UDP packet to the SIP
server in order to keep the "hole" on the NAT open. Default is 20 seconds. Minimum
value is 20 seconds.
Use STUN keep-alive to detect WAN side network problems. If keep-alive request does
not yield any response for configured number of times, the device will restart the TCP/IP
stack. If the STUN server does not respond when the device boots up, the feature is
disabled. Default setting is No.
Enables HT70X to download firmware or configuration file through either the TFTP, HTTP
or HTTPS server.
HT-70X User Manual
Firmware Version 1.0.0.18
DND Forward Busy
Forward
Yes 613
Last Updated: 03/2012
Delayed
Forward
The
Page 20 of 35