Programme Reset; Special Functions - Bosch SRS4002GB Repair Instruction

3.1.3 Display
A 2½-digit 7-segment display enables programme run times, etc., over
99 min. to be displayed. The remaining running time is recalculated at
the end of the heating positions. If deviations occur on account of the
aqua sensor decisions, water supply temperature, number of utensils,
etc., the indicated remaining running time is corrected in these
positions. Therefore, at the end of the wash cycle and final rinse the
time may jump by up to 20 minutes.
3.2

Programme reset

When the appliance is switched on, simultaneously press the S2 and
the S4 buttons for 3 sec. The appliance is drained for approx. one
minute. Then close the detergent dispenser to reset the dispenser.
58300000002393_ara_en_a.doc – 31.07.07
3.3

Special functions

3.3.1 Setting the hardness range
Hold down the S3 button and switch on the appliance. The set value is
indicated on the digital display. The set value increases by one each
time the S3 button is pressed. When "7" is reached, the display jumps
back to "0". If the appliance is switched off, the value is saved.
°dH °fH °Clarke mmol / l
0-6 0-11 0-8
7-8 12-15 9-10 1.2-1.4
9-10 16-17 11-12 1,5-1,8
11-12 18-21 13-15 1.9-2.1
13-16 22-29 16-20 2.2-2.9
17-21 30-37 21-26 3.0-3.7
22-30 38-54 27-38 3.8-5.4
31-50 55-89 39-62 5.5-8.9
Standard setting = 4
3.3.2 Setting the intensive drying
Hold down the S2 button and switch on the appliance. "0" is indicated
on the digital display. If the S2 button is pressed again, "1" is
displayed and intensive drying is switched on. If the appliance is
switched off, the value is saved. If intensive drying is activated, the
temperature is increased by 3 K in the final rinse.
Salt consumption
per rinse cycle in g
0-1.1 ---
4
7
9
14
18
27
54
Set value
0
1
2
3
4
5
6
7
Seite 6 von 60