Interrupting The Programme; Terminating The Programme (Reset); Changing The Programme; Intensive Drying - Bosch SKE53M05AU Operating Instructions Manual

Switching off the appliance
Short time after the end of the programme:
– Switch off ON/OFF switch (.
– Turn off the tap (not applicable if Aqua-
Stop fitted).
– Open the door.
– Remove the utensils when they have
cooled down.
m
Warning
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.

Interrupting the programme

– Switch off ON/OFF switch (.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave the
door ajar for several minutes and then
close. Otherwise, expansion (pressure)
may cause the appliance door to
spring open or water to run out of the
appliance.
– To continue the programme, switch on
the ON/OFF switch ( again.
T erminating the programme
T e r m i n a t i n g t h e p r o g r a m m e
(Reset)
– Press START button H for
approx. 3 sec.
The numerical display `
indicates :
– The programme sequence lasts
approx. 1 min. On the digital
display ` is indicated :
– Switch off ON/OFF switch (.
.
.

Changing the programme

When the START button H has been
pressed, the programme cannot be
changed.
The only way a programme can be
changed is by Cancel programme (Reset).

Intensive drying

The final rinse uses a higher temperature
which improves the drying result. The
running time may increase slightly.
(Caution if utensils are delicate!)
– Close the door.
– Switch on ON/OFF switch (.
– Hold down programme button # and
press START button H until the
digital display ` : ... is indicated.
– Release both buttons.
To change the setting:
– Press the button 3 to switch the
Intensive drying on :
– Press START button H.
The set value is saved.
en
or off : .
13