Download  Print this page

Advertisement

Control panel message
008–Microcode Patch Error
009–PMM Allocation Error during MEBx
Download
00A-Product Information Not Valid
00B-MEBx Module did not checksum correctly
00C-PMM Deallocation Error during MEBx
Cleanup
00D-Setup Error during MEBx Execution
80
Chapter 7 POST error messages and diagnostic front panel LEDs and audible codes
Description
RTC (real-time clock) battery may need to
be replaced.
Processor is not supported by the BIOS.
Memory error during POST execution of the
Management Engine (ME) BIOS Extensions
option ROM.
The product information programmed into the
system board is missing or invalid.
Memory error during POST execution of the
Management Engine (ME) BIOS Extensions
option ROM.
Memory error during POST execution of the
Management Engine (ME) BIOS Extensions
option ROM.
MEBx selection or exit resulted in a setup
failure.
Recommended action
problem persists, replace the RTC battery. See
the Removal and Replacement section for
instructions on installing a new battery.
1.
Upgrade BIOS to proper version.
2.
Change the processor.
1.
Reboot the computer.
2.
Unplug the power cord, re-seat the
memory modules, and reboot the
computer.
3.
If the memory configuration was recently
changed, unplug the computer, restore
the original memory configuration, and
reboot the computer.
4.
If the error persists, replace the system
board.
Use Computer Setup to update this information.
1.
Reboot the computer.
2.
Unplug the power cord, re-seat the
memory modules, and reboot the
computer.
3.
If the memory configuration was recently
changed, unplug the power cord, restore
the original memory configuration, and
reboot the computer.
4.
If the error persists, replace the system
board.
1.
Reboot the computer.
2.
Unplug the power cord, re-seat the
memory modules, and reboot the
computer.
3.
If the memory configuration was recently
changed, unplug the power cord, restore
the original memory configuration, and
reboot the computer.
4.
If the error persists, replace the system
board.
1.
Reboot the computer.
2.
Unplug the power cord, re-seat the
memory modules, and reboot the
computer.
3.
If the memory configuration was recently
changed, unplug the power cord, restore
the original memory configuration, and
reboot the computer.
4.
If the error persists, replace the system
board.

Advertisement

Table of Contents

This manual is also suitable for:

Prodesk 600 g4Elitedesk 705 g4

Comments to this Manuals

Symbols: 0
Latest comments: