Download  Print this page

Advertisement

System board

NOTE:
All system board spare part kits include replacement thermal material.
NOTE:
System board appearance may vary.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
In models with a hard drive, remove the hard drive
on page
4.
Remove the fan
5.
Remove the heat sink
6.
When replacing the system board, make sure the following components are removed from the defective
system board and installed on the replacement system board (as applicable):
Memory modules
M.2 solid-state drive
Processor
WLAN module
Expansion connector board
7.
To remove the system board:
a.
On models with a hard drive, disconnect the speaker cable from the system board (1), and then
remove the three Torx T15 screws (2) that secure the system board to the computer.
(Access panel on page
22.
(Fan on page
31).
(Heat sink on page
(Memory modules on page
(M.2 PCIe solid state drive (SSD) on page
(Processor on page
(WLAN module on page
(Preparation for disassembly on page
16).
(Hard drive on page
32).
28)
34)
24)
(Expansion connector board on page
15).
20) and drive cage
Drive cage
23)
27)
System board
35

Advertisement

Table of Contents

This manual is also suitable for:

Prodesk 600 g4Elitedesk 705 g4

Comments to this Manuals

Symbols: 0
Latest comments: