Table of Contents
Advertisement
(can go off in sleep modes or always stay on; by default it goes off in sleep modes). It is used for
the 10 kΩ pullup resistor power on the 8x GPIOs and usually for the 2x Ethernet LEDs, however,
the Ethernet LEDs can be powered by a 3.3 V power source.
Cabling
An adapter cable, part number CBR-4005A, is available for connecting the VL-CBR-4005B
paddleboard to the EPU-4562/4462. This is a 12-inch, Pico-Clasp 40-pin to 40-pin cable
If your application requires a custom cable, the following information will be useful:
On-board Battery
CAUTION:
To prevent shorting, premature failure or damage to the Lithium battery, do not
place the board on a conductive surface such as metal, black conductive foam
or the outside surface of a metalized ESD protective pouch. The Lithium battery
may explode if mistreated. Do not recharge, disassemble, or dispose of the
battery in fire. Dispose of used batteries promptly.
Nominal battery voltage is 3.0 V. If the voltage drops below 2.7 V, contact the factory for a
replacement. The life expectancy under normal use is approximately five years.
VL-EPU-4562/4462 Reference Manual
CBR-4005B Board Connector
Molex 501571-4007
VL-CBR-4005B Paddleboard
Mating Connector
Molex 501189-4010
58
Advertisement
Table of Contents
