Com Port Configuration; Console Redirection - VersaLogic Blackbird VL-EPU4562 Hardware Reference Manual

If your application requires a custom cable, the following information will be useful:

COM Port Configuration

Jumper blocks V1 and V2 configure the serial ports for RS-232 or RS-485/RS-422 operation. See
the section titled "Jumper Blocks" on page 16 for details. The termination resistor should only be
enabled for RS-485 or RS-422 endpoint stations and not for intermediate stations. Termination
must not be used for RS-232.

Console Redirection

The Blackbird can be configured for remote access by redirecting the console to a serial
communications port. The BIOS Setup utility and some operating systems (such as MS-DOS)
can use this console for user interaction. The default settings for the redirected console are as
follows:
115,200 baud rate

8 data bits, No parity, 1 stop bit (that is, 8-None-1)

No flow control

VL-EPU-4562/4462 Reference Manual
EPU-4562/4462 Board Connector
Molex 501331-1007
Mating Connector
Molex 501330-1000
Serial I/O
46