Matthews Marking Systems I-Mark SX-32e Technical Manual page 6

I N T R O D U C T I O N
4
Please note the following warnings:
• Please read all instructions before using the printer for the first time.
• The printer should be connected to the power supply indicated on the voltage
plate. If you are unsure of the type of power supply available, please contact
MSAB or MPD service personnel.
• The printer is equipped with a plug suitable for grounded sockets. This is a safety
measure. If the plug does not fit the power socket, it must be replaced by a quali-
fied electrician.
• We do not recommend the use of extension cables.
• The power cable must not be subjected to pressure.
• Ensure that the printer is not placed anywhere where the cable can be stood on or
snagged.
• Do not attempt to open the electronic unit or other sealed parts. These parts cannot
be serviced by the user.
• Never point the nozzle end of a print head at yourself or another person.
• Never expose the unit to liquids or high humidity.
• All chemicals, even ink, may present unknown health hazards, and should be
treated with caution. Please refer to the Material Safety Data Sheet for further
information.
• Always disconnect the power cable before performing any service or maintenance
on the printer.
• Never use sharp or pointed tools when cleaning or replacing the print head.
• Disconnect the power to the printer and call in qualified personnel under the fol-
lowing conditions:
The power cable or plug is damaged or worn • Liquid has been spilled on the
printer • Rain or water has got into the printer • The printer is not functioning cor-
rectly despite the user following the instructions for use • You have dropped the
printer or the casing has been damaged. • The printer is not functioning correctly
and requires service.
I•Mark SX-32e Technical Manual Version: 8 Issue: 1