Introduction; Conditions; Safety & Certification - Matthews Marking Systems I-Mark SX-32e Technical Manual

For information on basic
procedures such as
navigating the menu
structure and getting
help, please see the
"Getting Started" chapter
of the Operator Manual.
For specific information
on print heads or ink
supply units, please see
the relevant
documentation.
I•Mark SX-32e Technical Manual Version: 8 Issue: 1
© Copyright Matthews Swedot AB, Gothenburg 2006.
Contact details - Manufacturer
USA
Matthews Marking Products
6515 Penn Avenue
Pittsburgh, PA 15206
Phone: +1 412 665-2500

Conditions

Matthews Swedot AB reserves the right to change specifications in both the text and
illustrations without prior notice. The contents of this publication may not be copied,
either wholly or in part, without permission.
Neither Matthews Marking Products nor Matthews Swedot AB can be held respon-
sible for any direct, indirect, specific, accidental or resultant injuries caused by a fault
with the machine system or software, or by an error in the accompanying documen-
tation. In particular, neither Matthews Marking Products nor Matthews Swedot AB
can be held responsible for any program or data stored or used with Matthews'
products, including the cost of recovering such programs or data.
Safety & Certification
This symbol and text format is used throughout this manual to indicate
circumstances that may be dangerous to the user or that can cause damage to the
equipment.
This symbol and text format is used throughout this manual to draw your
attention to important information and tips.
Safety Requirements
Matthews Swedot AB and
regarding the CE directive if the printer is used, altered or installed in any way other
than described in this manual.
Sweden
Matthews Swedot AB
Gamlestadsvägen 8
415 02 Gothenburg
Phone: +46 (0)31 3387900
Matthews Marking Products

INTRODUCTION

disclaim all responsibility
3