Graco ProMix 2KS Operation Manuals page 51

Select a Component B Restrictor Size
Install the 15U955 Injection Kit in the fluid manifold as
explained in the ProMix 2KS Installation manual. Use
the charts provided in that manual to select an appropri-
ate restrictor size based on the desired flow and mix
ratio.
Turn On Dynamic Dosing
1. On the EasyKey press the Setup
the Set Up Home screen. Select "System Configu-
ration" to access the configuration screens. F
F . 53. Set Up Home Screen
IG
2. Navigate to System Configure Screen 4. Select
"DD" option from the "Dose Size" drop down menu.
F . 54.
IG
F . 54. Configure Screen 4, dynamic dosing
IG
selected
312776K
3. Selecting "DD" in System Configure Screen 4
makes the DD Setup mode available. See F
To enable DD setup mode, select On in the DD
setup mode drop down menu. This disables Off
Ratio alarms E-3 and E-4, allowing uninterrupted
setup and tuning.
NOTE: Do not use the material mixed when in DD setup
mode, as it may not be on ratio due to the disabled
alarms.
key to access
NOTE: If DD setup mode is not turned Off at the end of
setup, it will automatically turn off 3 minutes after initia-
. 53.
IG
tion of a Mix command.
F . 55. Configure Screen 4, dynamic dosing setup
IG
mode enabled
System Operation
. 55.
IG
51