Service Procedures; Component Access (Upper Housing Removal And Surround Access) - KitchenAid KSB5010 Service & Repair Manual

Normal electrical testing techniques, using a volt/ohm
meter, are sufficient to test the products electrical
components.
NOTE: Refer to the Troubleshooting Quick Reference
Guide (Appendix B) in the back of this manual while
performing any test.

Review any documentation accompanying the faulty
appliance.

Perform a ground continuity test and a dielectric
withstand (HiPot) test prior to plugging the product
into an electrical outlet.

Prior to disassembling the product, plug it into an
electrical outlet and perform a function test. Test the
switches, speed selections, etc. for proper operation
and to troubleshoot for the problem.

After troubleshooting, use the SERVICE
PROCEDURES to replace any faulty component.

SERVICE PROCEDURES

This manual is written as a step-by-step guide to
disassemble and reassemble the KitchenAid
Blender to gain access to the systems within the unit that
are in need of repair. For models covered in this manual,
refer to the index page.
®
Most of the KitchenAid
are contained within the blender's motor surround
housing. Perform the Component Access Procedure
(below) to gain access to the blender components.
NOTE: When removing self-tapping screws from any
plastic or metal housing, the filings created will be
scattered onto adjoining components. Prior to performing
any reassembly procedure, make sure to remove all the
filings using clean rags, low-pressure compressed air,
etc.
Use of the Troubleshooting Quick Reference Guide
(Appendix B) will aid in determining what steps are
necessary for repairing the unit. Not all steps will be
needed for some of the repairs so it is important to
consult the Troubleshooting Quick Reference Guide first.
®
Torrent™
Torrent™ Blender components
Appendix D lists all of the screw torques required for
proper reassembly of the unit.
Component Access (Upper Housing
Removal and Surround access)
Most replacement procedures will require access to the
inside of the product. To gain access to the components:
1. Unplug the power cord.
2. Remove the 8-32 X .540 screw on the back of the
blender that secures the upper housing to the
surround (Fig. 1).
3. With the ingredient cap, collar, jar and lid removed,
turn the food processor upside-down on a cushioned
surface (a soft towel is recommended).
4. Remove the (2) remaining 8-32 X .540 screws from
the underside of the upper housing assembly (Fig.
2).
Fig. 1) Remove the screw at the back of the upper housing
Fig. 2) Remove the (2) screws that secure the upper cover to
the upper housing
- 8 -