Surround And Power Cord Removal - KitchenAid KSB5010 Service & Repair Manual

21. Remove the electronic control circuit board
grounding screw from the inside of the surround
housing (Fig. 21).
Fig. 21) Remove the control ground wire from the inside of
the surround housing (International Models only)

Surround and Power Cord Removal

22. Remove the (2) screws that secure the speaker box
to the surround housing and set the speaker aside
on the workbench (Fig. 22).
Fig. 22) Remove the speaker box screws
23. Remove the (2) screws that secure the surround to
the lower housing from the top of the unit (Fig.23).
Note: There are 2 more screws that will be removed in
step 24 to complete the removal of the surround housing
from the lower housing.
Fig. 23) Remove 2 screws that hold the surround to the lower
housing from the top
24. Invert the unit on the workbench and remove the (5)
rubber feet from the base by pulling them up and out
with your fingers (Fig. 24).
Fig. 24) Remove the rubber feet from the base to expose the
base hold down screws
- 13 -