Fig. 39) move the belt onto the next groove in the pulley
42. A properly installed belt will resemble Figures 40 &
41. Figure 40 shows the belt ribs aligning with the
pulley grooves on the coupler pulley. Figure 41
shows the belt ribs aligning with the grooves in the
motor pulley.
Fig. 40) belt ribs lined up with the grooves in the lower
coupler pulley
Fig. 41) belt ribs lined up with the grooves in the motor pulley
Lower Housing reassembly
43. Once the belt has been properly installed, the lower
housing cover can be placed back over the lower
coupler and screwed into place with the (4) 8-16 x
.562 screws that were removed in step 28 (Fig. 42).
Fig. 41) put the lower housing cover in place and secure with
the (4) screws.
- 18 -