KitchenAid KSB5010 Service & Repair Manual page 11

Fig. 12) Use a small flat blade screwdriver to release the front
(plastic) housing and upper cover.
Fig. 13) slide the upper cover and front (plastic) housing out
from the unit.
15. The upper cover can be removed from the front
housing by loosening the (2) 8-16 x .562 screws that
secure it to the front housing. Once the screws have
been loosened, the upper cover should easily lift off
the front housing (Fig. 14).
Note: There is no need to fully remove the (2) screws as
loosening them is enough to allow the removal of the
upper cover.
Fig. 14) Loosen the two screws on the back of the front
plastic cover to release the upper cover.
16. Remove the upper blender seal (rubber) from the
upper cover (Fig. 15) and replace if it is damaged.
Fig. 15) Remove and replace the upper blender seal if it is
damaged.
- 11 -